A Procurement Engineer’s Guide to Figure-8 Blinds: Design, Standards, and RFQ

Standards to Confirm

When procuring figure-8 blinds, verify compliance with these international standards:

• ASME B16.48: Standard for line blanks and spectacle blinds. Covers dimensions, pressure-temperature ratings, and materials.
• API 590: Specification for steel spectacle blinds (commonly used in refinery applications).
• ASME B16.5: For flange facing and drilling patterns (if blind is between flanges).
• Material standards: e.g., ASTM A105 for carbon steel, ASTM A182 for alloy/stainless.

Always request the manufacturer’s design code and confirm the blind is rated for your system’s maximum allowable working pressure (MAWP).

Inspection Documents Required

For quality assurance, request these inspection documents:

• Material Test Reports (MTRs): Certified from the mill, confirming chemical composition and mechanical properties.
• Dimensional Inspection Report: Verifies OD, length, thickness, and bolt hole alignment (if any) per ASME B16.48.
• Nondestructive Examination (NDE): For critical service, specify ultrasonic testing (UT) or magnetic particle inspection (MPI) on the weld neck (if applicable) or plate.
• Hydrostatic Test Certificate: Some orders require a pressure test to validate the blind’s integrity.
• Heat Number Traceability: Ensures full traceability from raw material to finished product.

RFQ Checklist

When requesting a quote, include the following details:

• Pipe size and schedule (e.g., 6" Sch 40)
• Pressure class (e.g., Class 150, 300, 600, etc.)
• Material grade (e.g., A105, F316)
• End connection type (raised face, ring joint, etc.)
• Quantity and delivery timeline
• Required certifications (e.g., EN 10204 3.1, NACE MR0175)
• Special testing (e.g., 100% UT, PMI)

Clarify whether the blind is for permanent or temporary service—this affects design safety factors.

Quality Risks to Watch

• Incorrect pressure rating: A blind rated below system pressure can rupture.
• Material mismatch: Using carbon steel in corrosive service leads to early failure.
• Poor dimensional tolerance: A blind that is too thin or has misaligned bolt holes will not seat properly.
• Lack of full traceability: Absence of MTRs or heat numbers makes quality verification impossible.

To mitigate, specify that all materials must come from approved mills and that the manufacturer holds ISO 9001 certification.

What to Send Before Quotation

To get an accurate and competitive quote, provide:

• Piping isometric or line list (showing location and service)
• Design conditions (temperature, pressure, fluid composition)
• Applicable codes and standards (e.g., ASME B31.3)
• Preferred material grade and any special coating
• Required third-party inspection (e.g., Lloyds, DNV)

A complete technical inquiry reduces back-and-forth and ensures the blind meets your exact needs.

RFQ CTA

Are you sourcing figure-8 blinds for your next project? Hebei Haihao Group manufactures high-quality spectacle blinds in carbon, alloy, and stainless steels, compliant with ASME B16.48 and API 590. Send your RFQ with the checklist above for a prompt quotation and engineering support.